Mould on a wall is a moisture problem, not a cleaning problem: wipe it off and it comes back until the moisture is dealt with. Treat the mould safely first, then cut the moisture that feeds it with heat, ventilation and less water vapour in the air. The steps below work for the black spots of condensation mould that appear in corners and behind furniture in winter. Damp from leaks or from the ground is a different problem and needs a professional.
Why does mould appear more in winter?
Mould grows where moisture, warmth and a surface to feed on meet, and winter brings all three together. Cold walls and corners collect condensation when warm, moist air from cooking, showering and drying clothes indoors touches them. Windows stay shut, so the moisture has nowhere to go, and shorter days mean less sun and less drying. Damp tends to cluster around cold spots, corners that do not heat evenly and gaps in insulation, which is why the same corner grows mould every winter while the rest of the wall stays clean. A load of washing dried indoors adds about 2 litres of water to the air, as covered in our guide How to Dry Clothes Indoors in Winter Without Damp.
What kind of damp is it?
Check the pattern before you treat it, since the fix depends on the cause. Condensation mould shows as black spots in corners, behind furniture, along skirting boards and around window frames, and it is worst in cold weather. Penetrating damp shows as a wet stain on a wall or ceiling that grows after rain, often near a roof, gutter or cracked render. Rising damp shows as a tide mark low on a ground-floor wall, with peeling paint or crumbling plaster below it. The steps in this guide deal with condensation mould. Penetrating and rising damp need a surveyor or damp specialist, since no amount of cleaning fixes water coming through the wall.
How to remove mould safely
Work through the steps in order, and do not skip the safety steps: mould spores irritate eyes and lungs, and disturbing mould the wrong way spreads it.
- Open a window and run the extractor fan so the room is ventilated while you work.
- Wear gloves and a mask, and keep children and pets out of the room.
- Never wipe mould with a dry cloth and never brush or vacuum it: dry wiping releases spores into the air and smears the growth into the surface instead of removing it.
- Wipe the wall with a fungicidal wash that carries a Health and Safety Executive approval number, following the maker instructions exactly. A diluted bleach solution of one part bleach to four parts water also works on hard surfaces.
- Use a firm sponge or dish brush for stubborn patches and a toothbrush for tight corners, then leave the surface to dry with plenty of ventilation.
- Throw away cloths and sponges used on mould instead of reusing them, since they carry spores to the next surface.
One caution: most fungicidal washes are made for hard surfaces such as tiles, not for plastered, painted or papered walls, and using them on the wrong surface can add moisture and make the problem worse. Read the label and match the product to the surface. After treatment, redecorate with a good quality fungicidal paint, and use a paste containing a fungicide if you re-paper: ordinary paint or wallpaper over the treated area destroys the effect.
How to stop mould coming back
Removing mould is the short job; keeping it away is the real fix. Mould only returns when moisture returns, so work on the four causes in turn.
Heat the home evenly
Keep some background heat on through the day in cold weather instead of heating one room hard and leaving the rest cold: the unheated rooms are where condensation forms. Rooms should stay at a minimum of 18°C for health. Move furniture a few centimetres away from external walls so warm air can reach the cold surface behind it, and keep radiators clear of curtains and wet washing. Our guide How to Keep Your House Warm Without Turning the Heating On covers low-cost ways to hold the heat you already have.
Ventilate every day
Ventilation is the single most important step. Run extractor fans in the bathroom and kitchen whenever you cook or shower, and keep trickle vents open where fitted. Open windows on opposite sides of the house for 20 to 30 minutes each morning to flush out the moisture that built up overnight. Do not cover air vents, and never block flues or air bricks that an appliance needs. Wipe windows and sills with a clean dry cloth each morning to remove the water that settled overnight, as covered in our guide How to Stop Condensation on Windows in Winter.
Cut the moisture at the source
Put lids on pans while cooking, keep the bathroom door closed while showering, and dry clothes outside where possible. If clothes must dry indoors, use a closed room with a window cracked open and good airflow, never a radiator: a dehumidifier in that room pulls the moisture out of the air, and its running cost is small, as shown in our guide How Much Does It Cost to Run a Dehumidifier?. A dehumidifier helps with condensation, but it is of limited use in a cold damp room, so heat and ventilation come first.
When to get help
If you rent, tell your landlord or managing agent as soon as mould appears, so they can deal with the cause: do not wait for it to spread. Get a professional survey when the mould covers a patch bigger than about a square metre, when it keeps returning after treatment, when the wall feels wet to the touch, or when the pattern points to penetrating or rising damp. See a doctor if anyone in the home develops a cough, wheeze or other breathing symptoms that line up with the mould, since damp housing can increase the risk of respiratory illness. Small condensation patches treated early rarely need a professional; large or returning patches almost always do.
Frequently asked questions
What kills mould on walls?
A fungicidal wash with a Health and Safety Executive approval number, used exactly as the label directs, or a diluted bleach solution of one part bleach to four parts water on hard surfaces. Never dry-wipe mould: it spreads spores instead of removing them.
Why does mould keep coming back on the same wall?
Because the moisture that feeds it is still there. Mould returns until the wall stays dry, which takes even background heat, daily ventilation and less water vapour in the air. Cleaning alone only removes the visible growth.
Does a dehumidifier stop mould?
It helps by pulling moisture out of the air, but it is of limited use in a cold damp room. Heat and ventilation come first: a dehumidifier works best in a room that is already warmed and ventilated.
Should I tell my landlord about mould?
Yes, as soon as it appears. The landlord needs to deal with the cause, and waiting lets the mould spread. Get a professional survey for large patches, mould that keeps returning, or damp that points to a leak or rising damp.
Sources
The safe removal steps, the fungicidal wash with a Health and Safety Executive approval number, the one part bleach to four parts water dilution, the warning against dry wiping and the ventilation and heating steps follow UK council damp and mould guidance from Braintree, North Devon, Richmond upon Thames and Adur and Worthing. The 18°C minimum room temperature follows British Red Cross winter warmth guidance. The 2 litres of water per load of washing dried indoors follows our drying clothes guide.
Changelog
- 7 November 2026: guide published.