How to Winterize a Lawn Mower

Home › Guides › How to Winterize a Lawn Mower

To winterize a lawn mower, do the job right after your final mow of the season and before the first hard frost. For a gas mower, drain the fuel tank or add fuel stabilizer, change the engine oil, replace the spark plug, clean the air filter, clean the deck and sharpen the blade, then store it somewhere dry. For a battery mower, skip the fuel and oil steps: clean it, take the battery out and store the battery indoors. For a robot mower, charge it fully, switch it off, clean it and store it indoors. The whole job takes about 60 to 90 minutes, and it is the single best thing you can do for the mower: a winterized mower starts first pull in spring, while a neglected one often refuses to start at all.

When should you winterize a lawn mower?

Winterize your mower right after the final cut of the season, once the grass has stopped growing and before sustained freezing temperatures arrive. In cooler regions that usually falls between mid-October and late November, and in warmer regions you may not need to winterize until December or even January. Do not wait for the first snow: untreated fuel starts breaking down in about 30 days once it sits in the tank, so fuel bought in early October is already going stale before any freeze shows up. The countdown starts at your last fill-up, not at the first frost. If you are not sure the grass has finished growing, mow once more at a slightly higher cutting height, then winterize the same day.

How to winterize a gas lawn mower

Work through these steps in order after your last mow. The fuel step matters most: fuel left in the tank over winter degrades, gums up the carburetor and causes hard spring starts, and it is the number one cause of mowers that refuse to start in spring.

  1. Empty the gas tank or add fuel stabilizer. Run the engine until the tank is empty and the engine dies on its own, which clears the fuel lines and carburetor too. Or add stabilizer to fresh fuel at the ratio on the bottle, usually 1 ounce per 2 to 2.5 gallons, fill the tank almost to the top to leave less air space for moisture, then run the engine for about 10 minutes so the treated fuel reaches the carburetor. Do one or the other, never both.
  2. Change the engine oil. Warm the engine up first so the old oil drains out cleanly, then drain it and refill with the oil type listed in your owner’s manual, usually SAE 30 for warm climates or 5W-30 for variable temperatures. Old oil holds moisture and contaminants that damage the engine over winter.
  3. Replace the spark plug. Pull the old plug, check the gap on the new one, usually 0.030 inches, and fit it. Change the plug after every 50 hours of use, and a fresh plug makes spring starting far easier.
  4. Clean or replace the air filter. A foam filter can be washed and re-oiled, a paper filter should be replaced if it is dirty. Do this while the spark plug is out, since it is easier to reach.
  5. Clean the deck and sharpen the blade. Disconnect the spark plug wire first: a mower can fire from a single turn of the blade, even by hand. Scrape the dried grass off the underside of the deck, then sharpen and balance the blade and refit it.
  6. Store it with care. Put the mower in a dry, ventilated spot such as a garage or shed, off the ground on a pallet or mat if you can, under a breathable cover rather than an airtight tarp. Keep it away from heat sources and open flames.

Gas mowers need all six steps. The fuel and oil steps protect the engine, the spark plug and air filter protect the starting, and the deck cleaning stops rust eating the underside all winter. Manufacturer guidance suggests that consistently winterized equipment lasts an average of two to three years longer than neglected machines and cuts spring startup problems by roughly 80 per cent.

How to winterize a battery or electric mower

Battery and corded electric mowers skip the fuel, oil, spark plug and air filter steps, and focus on cleaning, blades and battery storage. Clean the deck and the wheels, scrape off dried grass and wipe the body with a damp cloth, avoiding spraying water straight into the motor or the electronics. Sharpen or replace the blade if it is dull. Then take the battery out and store it indoors in a cool, dry place, away from heat sources such as furnaces or water heaters. Store it at about 50 to 60 per cent charge, or connect it to a battery tender if your maker recommends one. Cold and damp are what harm a battery over winter, so never leave it sitting in an unheated shed on a concrete floor: put it on a wood shelf indoors instead. For a corded mower, coil the cable loosely and check it for cuts or damage before you put it away.

How to winterize a robot lawn mower

A robot mower has no fuel or oil, and the battery is the one thing that needs protecting from a hard winter. Place the mower on its charging dock and let it fully charge, then switch the main power off completely so the battery does not drain slowly while it sits unused. Clean the mower thoroughly, including the wheels, the cutting disc and the underside, and fit the protective cover over the navigation sensor if your model has one. Then disconnect the charging station, clean it, and store both the mower and the station indoors in a dry place. Do not leave the charging station outside in snow and freezing rain: the cold damages the battery and the electronics, and the station itself is not built for months of winter weather.

How to winterize a riding lawn mower

A riding mower follows the same gas steps as a push mower, with a few extras. Drain or stabilize the fuel and change the oil the same way, then clean the deck and sharpen the blades, which on a riding mower means raising the deck or removing it. Take the battery out, or connect it to a battery tender and leave it on the mower, and clean the battery terminals. Check the tyre pressure and inflate the tyres to the pressure in the manual, since tyres lose pressure and flat-spot over a winter of sitting still. Grease the fittings listed in the manual, tighten loose bolts, and store it under a breathable cover in a dry garage or shed, with rodent deterrent in place: mice love to nest in a riding mower engine over winter and chew the wiring.

What happens if you skip winterizing?

The most common result is a mower that will not start in spring. Stale fuel gums up the carburetor, which is the most frequent spring repair, and a carburetor clean or rebuild costs far more than a bottle of stabilizer. Old oil left in the engine holds moisture and acids that corrode internal parts. A dirty deck rusts from the underside, and grass left caked on the blade unbalances it and strains the engine. A battery left in the cold loses capacity and can fail outright, and a robot mower left outside all winter can come back with a dead battery and water damage. Moisture is the thread through all of it: a dry mower stored with fresh oil and treated fuel usually starts first pull, while a wet mower with stale fuel usually does not.

Spring startup checklist

  • Fill the tank with fresh fuel, or check the stabilizer-treated fuel still smells fresh.
  • Check the oil level and top up if needed.
  • Refit the battery, or check the charge on a battery mower.
  • Check the spark plug wire is connected and the air filter is clean.
  • Check the blade is sharp and tight, and the deck is clear of debris.
  • Check the tyres on a riding mower and inflate to the manual pressure.
  • Start the mower outside, let it warm up for a few minutes, and listen for rough running before the first cut.

If the mower does not start, check the fuel first: drain any fuel left from last year and refill with fresh fuel, since stale fuel is the usual cause. If it still does not start, check the spark plug and the air filter, then the carburetor. Most spring starting problems trace back to one of those three, and all three are preventable with the winterizing steps above. For the rest of the house, see our guide on how to winterize a house.

Frequently asked questions

When should I winterize my lawn mower?

Right after your final mow of the season, before the first hard frost. In cooler regions that is usually mid-October to late November, and in warmer regions December or January. Untreated fuel starts breaking down in about 30 days, so do not wait for the first snow.

Should I drain the gas or use fuel stabilizer?

Either works, but never both. Drain the tank by running the engine until it dies, which clears the fuel lines and carburetor. Or add stabilizer at the ratio on the bottle, usually 1 ounce per 2 to 2.5 gallons, fill the tank almost full and run the engine for 10 minutes so treated fuel reaches the carburetor.

Do battery mowers need winterizing?

Yes, but the job is shorter. Skip the fuel, oil, spark plug and air filter steps, and focus on cleaning the deck and blades and storing the battery indoors at about 50 to 60 per cent charge, in a cool, dry place away from heat sources.

Can I leave my lawn mower outside all winter?

It is not recommended. Leaving a mower outside exposes it to rain, snow, humidity, temperature swings and frost, and moisture is the most common cause of off-season damage. Store it in a dry garage or shed under a breathable cover, off the ground if you can.

Sources

The nine-step sequence of draining or stabilizing fuel, changing the oil, replacing the spark plug, cleaning the air filter, removing the battery, sharpening the blades and storing under a breathable cover, the stabilizer dose of 1 ounce per 2 gallons, the 10 minute run to pull treated fuel through the lines, and the oil and spark plug change interval of 50 hours follow a lawn mower winterizing guide updated in November 2026. The point that untreated fuel starts breaking down in about 30 days, the fuel steps for gas mowers, and the four-step robot mower sequence of full charge, power off, deep clean and indoor storage follow a lawn mower winterizing guide. The universal steps of cleaning, blade care, lubrication and dry ventilated storage, and the battery storage guidance for cordless and riding mowers, follow a lawn mower winter storage guide. The 60 to 90 minute job time, the mid-October to late November window for cooler regions, and the manufacturer guidance on winterized equipment lasting two to three years longer with roughly 80 per cent fewer spring startup problems follow a winter storage guide.

Changelog

  • 16 November 2026: guide published.

Leave a Comment